KC Mock

1. What is MPD? Can you briefly describe it?

2. How do you remove water on ground? What about during flight? Which system is used to remove the water?

3. When there is fuel spillage on tarmac during refueling, what must you do?

4. What do you understand about TE flap dynamic load relief? Briefly describe it to me.

5. During WAC, you found a dent on the aircraft, which is within the SRM limit, what must you do next?? (long answer, please approach me to explain to you the documentation flow)

6. What type of hydraulic fluid we use on B744?

ANSWER: LD-04 (Skydrol is the brand name, LD-04 is the content specification)

7. What is the different between e.g. BMS 3-11, Skydrol LD-04?

8. How do you power up the aircraft? Before connect the external power, what must you do?

i only post the new question, the other is just the same as the rest of you

Zana's Mock

1. What do you do in transit check?

2. What is the wheel wear limit? How many indicator pin are there on the brake? What is the wheel change procedures?

3. If you’ve put the wheel thread protector, and the wheel cannot put in, what is the problem?

4. What is the latest IN for wheel?

5. Engine inlet inspection. What do you look out for? What if you found bird feather on the inlet?

6. How do you check for fuel panel leak? How do you know it’s fuel or water?

7. Why is there a rivet smoke?

8. Can you use handphone during transit check?

9. What is tech log? Describe the tech log.

10. If there is a defect, how do you write in the DDL? What colour is it?

11. Why do you need to transfer DDL to tech log?

12. What is the CRS statement?

13. What is the different type SI? What is the different between of the SI

14. What is IN, QN & MM? what is the different between them?

15. What is NPE? Who can authorize, erase and invalidate it?

16. What is the chapter of servicing?

17. What is the chapter of refueling?

18. How do you carried out refueling?

19. If it cut off before the preselect fuel figure, what must you do?

20. What is the purpose of fuel venting?

21. What are the different type of fuel scavenge?

22. Which hydraulic system can you do hydraulic transfer?

23. How do you do hydraulic servicing?

24. What is the purpose of the ram air?

25. How many heat exchanger are there on a air cond pack? Where is it located?

26. How is the air-cond flow?

27. What is the purpose of the water separator? Where is the water go after that?

28. Thrust reverser. Latch opening sequence.

29. How do you deactivate Thrust Reverser?

30. What is the TE flap mode?

31. How do you do IDG servicing?

32. How do you do engine oil servicing?

33. How do you power up the aircraft using the external power?

34. What’s the different of freighter and passenger aircraft external power/APU power usage?

35. During engine start, which pneumatic valve is close

Alvin Mock

MOCK INTERVIEW (ALVIN)

INTERVIEWER: TI LAWRENCE

DATE: 24 JAN 2008

TIME: 1430HRS TO 1530HRS (60 MINS)

1. TRANSIT CHECK
1. RADOME
2. LEADING EDGE
3. FAN BLADE
4. IDG OIL
5. STATIC DISCHARGER
6. BOTH BRAKE INDICATION MISSING, HOW?
7. WHEEL WEAR LIMITS
8. PRESSURE VS EXTENSION
9. PRESSURE RELIEF VALVE @ FUEL ACCESS PANEL
10. STABILIZER
1. VENT SCOOP
2. STATIC DISCHARGER
3. OBVIOUS DAMAGE
   

2. WHEEL CHANGE: IN

3. HYDRAULIC FILTER CHANGE, PRECAUTIONS
1. DEPRESSURIZE SYSTEM & RESERVOIR

4. TECH LOG: WHAT ARE U SIGNING FOR?

5. RAISING DDLOG

6. REFUELLING

6. GREEN DISK
   

7. AIRCON
1. RAM AIR INLET FUNCTION
2. BLEED FLOW
3. WHEN IS ACM MOST EFFECTIVE?
4. WHERE WILL WATER GO AFTER WATER SEPARATOR?
5. WHAT CONTROLS TEMPERATURE IN THE INDIVIDUAL ZONES?
6. ZTC CONTROL WHAT COMPONENT?

8. ENGINE BLEED
1. WHAT VALVE CLOSE DURING STARTING?
2. WHAT VALVE OPEN?

Liyana Mock

MOCK INTERVIEW (LIYANA)

INTERVIEWER: TI LAWRENCE

DATE: 24 JAN 2008

TIME: 1100HRS TO 1207HRS (67 MINS)

1. ENG AOC REMOVAL / INSTALLATION
   

2. WHEEL CHANGE, PRECAUTIONS
   

3. EDP CHANGE, PRECAUTIONS
   

4. START VALVE CHANGE, PRECAUTIONS
   

5. WHAT IS SO SPECIAL ABOUT THE INSTALLATION OF THE START VALVE?
   

6. CMC ACTIVE FAULT – HOW DO YOU CARRY OUT THE TROUBLESHOOTING?
   

7. DESCRIBE THE TECH LOG
   

8. HOW TO CREATE A DDLOG ENTRY?
   

9. WHY MUST ENTER IN THE TECH LOG BEFORE OPENING A DDLOG ENTRY?
   

10. HOW LONG ARE THE BOOKS KEPT ON THE AIRCRAFT AFTER IT IS COMPLETELY FINISHED?
    

11. WATER RECORD BK: WHERE DO U FIND THE BK? HOW / WHERE TO GET THE AMOUNT OF WATER TO BE UPLIFTED FOR THE FLIGHT?
    

12. HYDRAULIC TRANSFER
    

13. PRECAUTIONS BEFORE WORKING ON HYDRAULIC SYSTEMS?
    

14. HOW TO ENSURE THAT THE HYDRAULIC SYSTEMS ARE COMPLETELY DEPRESSURIZED?
    

15. HYDRAULIC SERVICING
    

16. OIL SERVICING
    

17. REFUELLING
    

17. REFUEL TO 150,000KGS BUT STOPPED AT 148,000KGS.HOW TO PUT IN THE REMAINIG 2000KGS? ALL THE OTHER TANKS ARE COMPLETELY FILLED. LEFT ONLY CWT.
    

19. HOW DOES THE REFUEL VALVE OPERATE?
    

20. WHAT’S THE PURPOSE OF THE RESERVE FUEL IN THE RESERVE TANKS?
    

21. ARE THERE ANY PUMPS IN THE RESERVE TANK?
    

22. DEAD AIRCRAFT HOW DO U GO ABT CONNECTING GROUND POWER?
    

23. DIFFERENCE BETWEEN FREIGHTER AND PASSENGER AIRCRAFT FOR EXT POWER?
    

24. DIFFERENT TYPES OF SI. WHO ISSUE THEM?
    

25. TECH NEWSBITES, IN, QN, MAINT MEMO
    

26. MODES OF T/E OPERATION
    

27. AIRCON SYSTEM
1. RAM AIR INLET, PURPOSE
   

28. FUEL SYSTEM
1. FUEL VENTING
   

29. IDG QAD : HOW TO ENSURE PROPER INSTALLATION?
    

30. HOW TO DISCONNECT THE WASTE LINE?
    

31. WHAT COLOUR IS THE CLAMP? PURPLE
    

32. WHAT TOOLS ARE USED TO DISCONNECT THE CLAMP?
    

33. HOW TO OPEN / CLOSE T/R COWLING?
    

34. T/R DEACTIVATION?
    

35. WHEN DO U DO A BYPASS OF THE T/R?
    

36. WHY DO U HAVE TO BYPASS?
    

37. WHAT IS NPE? CAN U WRITE IN IT?
    

37. DURING WALKAROUND FOUND A DENT. CHECKED WITH SRM TO BE WITHIN LIMITS. WHERE DO U ANNOTATE THIS INFO? AIRCRAFT DAMAGE RECORD.

CAN’T REMEMBER IF THERE WERE ANY MORE QUESTIONS…

Elektra Mock

hyd - how to TE alternate extension

aircon- describe flow of bleedair in air con pack, wats the use of water separator

pneumatics - flow of bleed air frm engine for usage.

fuel -
scenario: if during refuelling, no. 4 tank stop at 12 000 the refuel valve light go off (valve is close), but it shd go to 14 000, u short of 2000, wat would u do?
i answer manual open the refuel valve. but he said if u cant leh... then i said i will go find out. i think maybe must adjust volumetric top off volume to 13000 bcuz its the limit of tank.


describe scavenge system, wat kind of pump is working (hydromechanical type)

documentation - scenario: hw to fill up DDL. say ur start vlv need to change, no spares avail. i said write MEL item no, tick NIL SPARE and write the defect.

wat's QN, IN, MM . they are issued by who?? RIE who approve? transit check?

if u found bird feathers at engine inlet, wat u do?

how do install IDG, starter? wat u install before?? he thinks i nvr work one.

Fahmi and Steven Mock (22 Jan 2008)

Read up more about your air-con and fuel systems coz he tend to focus more into these topics. Apart from that, he didn’t ask much… it lasted for about 40mins…

- Different types of SI

- Documentation

- How is hydraulic sys 4, 1, and 2 interconnected

- Various Servicing

- T/R Deactivation procedures

- Hydraulic transfer

- Different modes for TE/LE

Anti-Skid Deactivation Pin/Plug

zoo carnival - Water Station

after over dunno how many months, i got this photo.. taken during zoo carnival